Trip Meter Reset; Odometer; Clock Adjustment - Triumph Tiger 800 Owner's Handbook Manual

General Information
Warning
Do not attempt to switch between
odometer and trip meter display modes or
reset the trip meter with the motorcycle in
motion as this may lead to loss of
motorcycle control and an accident.

Trip Meter Reset

To reset either of the trip meters, select and
display the trip meter to be zeroed then press
button 'B' for 2 seconds. After 2 seconds, the
trip meter on display will reset to zero.
Note:
• When a trip meter is reset to zero,
the journey time, average fuel
consumption and average speed will
also be set to zero for that trip
meter.
To exit the trip meter, press and release
button 'A' until the desired display is visible.

Odometer

When the ignition is switched on, the
odometer will be displayed for 3 seconds
then the last selected trip meter will be
shown.
The odometer shows the total distance that
the motorcycle has travelled.
To access the odometer, with the motorcycle
stationary and in neutral press and release
button 'A' until set up is visible in the display
screen then press button 'B'. Press and
release button 'A' until odometer is visible.
To exit odometer, press
button 'A' until r turn is visible then press
E
button 'B'. Trip 1 will be visible in the display
screen.
26

Clock Adjustment

Do not attempt to adjust the clock with the
motorcycle in motion as this may lead to
loss of motorcycle control and an accident.
To reset the clock; with the motorcycle
stationary and in neutral turn the ignition to
the ON position. Press and release button 'A'
until set up is visible in the display screen.
Press button 'B' and t-SEt will be visible.
Press button 'B' again and either 24 Hr or
12 Hr clock will be shown. Press button 'A' to
select the desired clock display and then
press button 'B'. The hour display will start to
flash and the word Hour is visible in the
display screen.
To reset the hour display, ensure that the
hour display is still flashing and the word
Hour is visible. Press button 'A' to change the
setting. Each individual button press will
change the setting by one digit. If the button
is held, the display will continuously scroll
through in single digit increments.
When the correct hour display is shown,
press button 'B'. The minutes display will
begin to flash and the word Min is visible in
the display screen. The minutes display is
adjusted in the same way as for the hours.
and release
Warning