Coolant Level Inspection; Coolant Level Adjustment - Triumph Rocket III Handbook

Coolant Level Inspection

1. Expansion tank
2. MAX mark
3. MIN mark
4. Fluid level
Position the motorcycle on level ground and
in an upright position.
The coolant level within the expansion tank
can be inspected without removing any
covers.
Check the coolant level in the expansion
tank. The coolant level must be between the
MAX (upper line) and MIN (lower line)
marks. If the coolant is below the minimum
level, the coolant level must be adjusted.
Maintenance and Adjustment

Coolant Level Adjustment

Warning
Do not remove the expansion tank or
radiator pressure cap when the engine is
hot. When the engine is hot, the coolant
inside the expansion tank will be hot and
also under pressure. Contact with this hot,
pressurised coolant will cause scalds and
skin damage.
Allow the engine to cool.
1. Intake cover
2. Intake cover screws
Remove the intake cover as follows: Release
the two screws from its front and rear edges
and then slide it downwards to release it from
two support studs in its centre.
Remove the cap from the expansion tank,
and add coolant mixture through the filler
opening until the level reaches the MAX
mark. Refit the cap.
63