Cleaning; Preparation For Washing; Where To Be Careful - Triumph Rocket III Handbook

Cleaning

Frequent, regular cleaning is an essential part
of the maintenance of your motorcycle. If
regularly cleaned, the appearance will be
preserved for many years. Cleaning with cold
water containing an automotive cleaner is
essential at all times but particularly so after
exposure to sea breezes, sea water, dusty or
muddy roads and in winter when roads are
treated for ice and snow. Do not use
household detergent, as the use of such
products will lead to premature corrosion.
Although, under the terms
motorcycle warranty, cover is provided
against the corrosion of certain items, the
owner is expected to observe this reasonable
advice which will safeguard against corrosion
and enhance the appearance
motorcycle.

Preparation for Washing

Before washing, precautions must be taken
to keep water off the following places.
Rear opening of the exhausts: Cover with a
plastic bag secured with rubber bands.
Clutch and brake levers, switch housings on
the handlebar: Cover with plastic bags.
Ignition switch and steering lock: Cover the
keyhole with tape.
Remove any items of jewellery such as rings,
watches, zips or belt buckles, which may
scratch or otherwise damage painted or
polished surfaces.
Use separate cleaning sponges or cleaning
cloths for washing painted/polished surfaces
and chassis areas. Chassis areas (such as
wheels and under mudguards) will be
exposed to more abrasive road grime and
dust, which may then scratch painted or
Maintenance and Adjustment
polished surfaces, if the same sponge or
cleaning cloths are used.

Where to be Careful

Avoid spraying water with any great force
near the following places:
• Instruments.
• Brake cylinders and brake calipers.
• Under the fuel tank.
• Headstock bearings.
of your
Do not spray any water at all under the
rider's seat. The rider's seat has the engines
air intake ducts fitted to its base and any
water sprayed in this area could enter the
of the
airbox and engine, causing damage to
both items.
Use of high-pressure spray washers is not
recommended.
washers, water may be forced into
bearings and other components causing
premature wear from corrosion and loss of
lubrication.
Note:
• Use of soaps that contain high
levels of alkaline will leave a
residue on painted surfaces, and
may also cause water spotting.
Always use a low alkaline soap to
aid the cleaning process.
Caution
Caution
When using pressure
89