Appendix F - Fcc Statement And Telephone Problems; In The Event Of Telephone Operational Problems - FBII XL-1S Hookup And Installation Instructions

Table of Contents

Advertisement

FCC Statement and Telephone Problems
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Federal Communications Commission (FCC) Statement
This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following
statement for your information.
This equipment generates and uses radio frequency energy and if not installed and used properly, that is in strict accordance
with the manufacturer's instructions may cause interference to radio and television reception. It has been tested and found to
comply with the limits of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference
in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does not cause interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
If using an indoor antenna, have a quality outdoor antenna installed.
Reorient the receiving antenna until interference is reduced or eliminated.
Move the radio or television receiver away from the control/ communicator.
Move the antenna leads away from any wire runs to the control/communicator.
Plug the control/communicator into a different outlet so that it and the radio or television receiver are on different branch
circuits.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions.
The user may find the following booklet prepared by the Federal Communications Commission helpful:
Interference Handbook"
This booklet is available from the U.S. Government Printing Office, Washington, DC 20402. Stock No. 004-000-00450-7.
The user shall not make any changes or modifications to the equipment unless authorized by the installation Instructions or
User's Manual. Unauthorized changes or modifications could void the user's authority to operate the equipment.
In the event of telephone operational problems, disconnect the communicator by removing the plug from the RJ31X jack. Do
not disconnect the phone connection inside the communicator. Doing so will result in the loss of your phone lines. If the regular
phone works correctly after the communicator has been disconnected from the phone lines, the communicator has a problem
and should be returned for repair. If upon disconnection of the communicator, there is still a problem on your line, notify the
telephone company that they have a problem and request prompt repair service. The user may not under any circumstances
(in or out of warranty) attempt any service or repairs on the system. It must be returned to the factory or an authorized service
agency for all repairs.

In the Event of Telephone Operational Problems

A P P E N D I X
F
F–1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents