12
Adjusting the synchronizer
.05.11
Requirement
1. On a seam interruption the machine must position 4 mm past b.d.c.
2. After a thread trim the machine must position at t.d.c. of the take-up lever.
Carry out adjustment according to motor instruction manual.
12
Setting the parameters for machine positions
.05.12
Requirement
1. On a seam interruption the machine must position 4 mm past b.d.c.
2. After a thread trim the machine must position at t.d.c. of the take-up lever.
Carry out the setting as described in the Motor Instruction Manual, taking care that
parameter "702" is set at the value "40" and parameter "703" at the value "113", see
Chapter 12.06.02 Example of a parameter input.
(PFAFF 333-712/03)
(PFAFF 333-712/02)
Adjustment
12 - 22