Safety; Regulations; General Notes On Safety - Pfaff 333-712/02 Instruction Manual

Safety

1 Safety
1.01

Regulations

This machine has been made according to the European regulations indicated in the
conformity and manufacturer's declarations.
In addition to this instruction manual, please also observe all generally accepted statutory and
other legal requirements, including those of the user's country, and the valid pollution control
regulations! The locally valid regulations of the social insurance institution responsible for
occupational accidents, or other supervisory authorities, must be strictly adhered to!
1

General notes on safety

.02
1 - 1
The machine must only be operated when the instruction manual has been fully read and
understood, and only by operators who have had the necessary training!
All notes on safety and the instruction manual of the motor manufacturer must be read
before the machine is put into operation!
All notices on the machine referring to danger and safety must be observed!
The machine must be used for the purpose it is intended for and must not be operated
without its safety devices; all regulations relevant to safety must be adhered to.
When part sets are changed (e.g. needle, presser foot and needle plate), during threading,
when the workplace is left unattended and during maintenance work, the machine must
be isolated from the power supply by pressing the on/off switch or removing the plug from
the mains!
Daily maintenance work must only be carried out by appropriately trained persons!
Repairs and special maintenance work must only be carried out by qualified technical staff
or persons with the appropriate training! Exceptions to this are only allowed for
adjustment and function checks by appropriately trained personnel!
Repair work and special maintenance work must only be carried out by technical
personnel or by persons with the appropriate training!
Work on the electrical equipment must only be carried out by technical staff who are
qualified to do so!
Work on parts or equipment connected to the power supply is not permitted! The only
exceptions to this are specified in regulations EN 50110.
Conversion or modification of the machine must only be carried out under observation of
all relevant safety regulations!
Only spare parts which have been approved by us are to be used for repairs! We draw
special attention to the fact that spare parts and accessories not supplied by us have not
been subjected to testing nor approval by us. Fitting and/or use of any such parts may
cause negative changes to the design properties of the machine. We shall not accept any
liability for damage caused by the use of non-original parts.