8
Tension the V-belt/fit V-belt guard
.02
8
Tensioning the v-belt
.02.01
Fig. 8 - 04
8
Fitting the upper belt guard
.02.02
4
5
Fig. 8 - 05
1
1
3
2
Installation and commissioning
(only PFAFF 333-712/03)
Loosen nuts 1.
Tension v-belt by adjusting bracket 2.
Tighten nuts 1.
Fig. 8-04 shows a Quick motor.
If a different motor is used,
please refer to the instruction
manual of the motor
manufacturer.
2
If a large balance wheel is in
use, break off corner 1 of belt
guard part 3.
Screw stop piece 2 onto belt guard part 3.
Screw on belt guard part 3 onto the
housing.
Screw on belt guard part 4 onto the
housing.
Secure belt guard parts 5 and 6 onto the
table top.
6
8 - 3