8
Fitting the Quick-flange motor.
.02
Fig. 8 - 04
Loosen screws 1 and remove toothed belt wheel 2 from the motor shaft 3.
Attach bearing plate 4 to the motor 5 with screws 6 as shown in Fig. 8-04.
Slide toothed belt wheel 2 onto the motor shaft 3 and fasten with screws 1.
Slightly tilt bearing plate 4 with motor 5 to the side and place the toothed belt 7 on the
toothed belt wheels.
Align bearing plate 4 of motor 5 on the machine case and attach it with screws 8.
8
Fit the belt guard of the Quick flange-motor.
.03
3
1
2
Fig. 8 - 05
7
3
Installation and commissioning
8
2
1
4
Attach belt guard 1 with screws 2 and 3.
5
6
8 - 3