Table of Contents
Advertisement
From Installation
to Operation
At least 10cm
At least 2cm
Install the
refrigerator.
Installation area
The installation area should not be exposed to direct
sunlight or hot air, and should be well-ventilated
to avoid diminished cooling power and to
economise on the cost of electricity.
It should have little humidity
to prevent rusting
It should be strong and level
to prevent vibration and noise, half-shut doors,
and tilted doors.
Install a strong plate or board under the
refrigerator if the supports easily sink into the
floor. (For prevention of deformation or
discoloration due to heat or weight)
A place away from other devices
disturbance.
Leave space for heat ventilation
Leave at least 2cm of space on the right and left
and 10cm of space between the ceiling and the
top of the refrigerator
to allow heat to escape from the ceiling and the
sides of the refrigerator
Warning
Do not close the ventilation hole of the refrigerator or the
crack around the refrigerator.
If the refrigerant leaks, ignition or explosion may be caused.
Outside of the refrigerator
body gets hot.
Due to heat radiation, it becomes about 50
to 60°C when starting to use or in summer.
6
Dedicated
outlet that meets
the specified rating.
Connect the power supply.
*Connect power supply soon after
installing the refrigerator.
Use a dedicated outlet
Use a dedicated outlet for the power supply that meets the rating specified on the
rating label. (The rating label is located on the door-liner of the refrigerator
compartment.)
Warning
Using outlets that do not meet the specified rating or plugging in too many
leads into a single socket can cause heat build up or fire.
The refrigerator will not be damaged even if the power is
supplied soon after installation.
It takes a while for the refrigerator to cool, therefore supply
power as soon as possible.
Electrical Connections
Make sure this unit is properly grounded.
The unit should always be plugged into its own electrical outlet.
This will provide the best performance and prevent electrical circuits from being
overloaded and causing a fire.
Make sure that the electrical outlet provides the proper voltage.
Extension cords are not recommended.
If your unit is installed in the high humidity location, not only ground connection
but also installation of the earth leakage breaker is recommended.
If the power cord is damaged, purchase a new cord from MITSUBISHI
SERVICE CENTER. Make sure that the power cord is designed for this model.
If the power cord is damaged, call our MITSUBISHI SERVICE CENTER for
the replacement, in order to avoid a hazard.
It takes time for foods to cool down after
turning on the refrigerator.
down sufficiently.
as soon as possible.
It may take about 24 hours if it is hot around the
Until making first ice cubes
refrigerator.
The refrigerator is set to "regular ice making" at first.
If you make crystal ice, change the setting.
11
page
Hide quick links:
Advertisement
Table of Contents
