From Installation To Operation - Mitsubishi Electric MR-EX574X Operating Instructions Manual

From Installation to
Operation
Space of
2.5 cm or more
Space of
0.5 cm or more
1
Installation
Install the refrigerator at:
A place with good ventilation and not
exposed to direct sunlight or hot air
To keep good cooling performance and
reduce power costs.
A place with low humidity
To prevent it from rusting, electric shock
and fi re.
A strong and level place
To prevent vibration, noise, and ajar or
tilting doors.
To prevent deformation or discoloration
of the fl oor materials due to the weight or
heat.
If the refrigerator supports may sink into the fl oor,
lay a strong plate or board underneath.
A place away from other devices
To prevent noise or video interference
with devices such as televisions.
There should be space of 0.5 cm
on the left and right of the
refrigerator, and 2.5 cm or more
from the ceiling.
To allow heat to dissipate from the top and
the sides of the refrigerator.
Use in hot spring areas
Corrosion control treatment may be
required for the refrigerant circuit (pipe)
due to generation of corrosive gases.
Contact the retail store where you
purchased the refrigerator.
Warning
Do not obstruct the refrigerator vents
or the space around the refrigerator.
If refrigerant leaks, it may accumulate
and catch fi re or explode.
6
Dedicated
outlet that meets
the specifi ed rating.
2
Connect the power supply
* Connect power supply soon after installing the refrigerator
Use a dedicated outlet
Use a dedicated outlet for the power supply that meets the rating specified on
the rating label. (The rating label is located on the door-liner of the refrigerator
compartment.)
Warning
Using outlets that do not meet the specifi ed rating or plugging in
too many leads into a single socket can cause heat buildup or fi re.
The refrigerator will not be damaged even if the power is supplied
soon after installation.
It takes a while for the refrigerator to cool, therefore supply power
as soon as possible.
Electrical Connections
Make sure this unit is properly grounded.
The refrigerator should always be plugged into its dedicated electrical
outlet.
This will provide the best performance and prevent electrical circuits
from being overloaded and causing a fi re.
Make sure that the electrical outlet provides the proper voltage.
Extension cords are not recommended.
If your refrigerator is installed in the high humidity location, not only
ground connection but also installation of the earth leakage breaker is
recommended.
If the power cord is damaged, purchase a new cord from MITSUBISHI
ELECTRIC SERVICE CENTRE. Make sure that the power cord is
designed for this model, in order to avoid a hazard.
Power cords should only be replaced by a qualified person.
The outside of the refrigerator
and the rotating partition get hot.
• Heat dissipation
causes the temperature
to rise to about 50 to
60°C or even higher
when operation is fi rst
started, and during the
summer.
The rotating partition
•
may get hot when
heated by the heater.
Turn on the power of the
refrigerator as soon as
possible.
The refrigerator will not be
damaged even if you turn on
the power immediately after the
installation.
It takes time for cooling even
after turning on the refrigerator.
• Wait until the refrigerator has been
fully cooled before storing non-
cooled food or ice cream.
• Do not open the doors more than
necessary, and close them as soon as
possible.
When making ice for the fi rst time
Rotating
partition
When the weather is hot in summer, it
may take more than 24 hours.