Table of Contents
Advertisement
Turn on the power of the
refrigerator as soon as possible.
The refrigerator will not be damaged even
if you turn on the power immediately after
the installation.
Refrigerator/Front side bottom
Adjustment and Anchoring
Turn the adjustable supports until
they touch the floor and the
casters are raised from the floor
Closing the doors
completely
Adjust the adjustable
supports to install and
secure the refrigerator
at level. Raise the
front part of the
refrigerator so that you
can close the doors
easily.
When adjustable supports are insufficient
corner of a room, one of the rear
legs may sink, causing the
refrigerator to tilt. If it is the case,
use a caster support or a sturdy
board for adjustment. (Normally,
the thickness of the board is 2 to 3
mm as a guideline.)
Do not cause damage to refrigerant
circuit (piping) / Do not attach screws.
Non-freon refrigerants are flammable gas. However, it is
hermetically sealed, therefore, leaking is infrequent.
Warning
Just in case of having damaged
the refrigerant circuit.
1. Do not use electric items or fire equipments near by.
2. Open the window and ventilate the room.
And then contact the retail store you have purchased from for
further instructions.
Adjustable
Caster
support
to prevent vibration and noise,
transmigration and half-shut doors
Caution
Insufficiently adjusted supports can cause
injury due to migration of the refrigerator.
Adjusting titled doors and an uneven refrigerator
Readjust the adjustable supports as
shown in the figures below.
The right door
The left door
sags down.
sags down.
Right
Left
Raise the right side.
Raise the left side.
Turn each adjustable
support in the arrow
direction until they
touch the floor.
If the installation area is
not level or the refrigerator
supports sink after a few
days due to the weight of
the food, the doors will
appear lower. (Depending
on the quantity of food, the
food weight can exceed
100 kg.)
Turn the adjustable
support to the direction
shown in the figures for
readjustment.
Rear leg
Caster support
or sturdy board
Prepare for earthquakes
Thread strong belts through the 2
handy-grip recesses on the top-rear of the
refrigerator and secure them to the wall,
posts or another strong area.
Warning
Your refrigerator tipping over can cause injury.
Leg cover
Leg Cover
The leg cover is bundled in
the refrigerator compartment
before shipment from the plant.
How to attach leg cover
Fully push in the leg cover
horizontally until it comes
into contact with the mating
part of the refrigerator.
Leg Cover
Adjustable support
Strong
belts
7
Hide quick links:
Advertisement
Table of Contents
