Table of Contents
Advertisement
9
Switching on/adjusting the bobbin thread control with reverse stitch
.09
count
Switch on the machine.
2 x
Press the TE/Speed key twice to call up the parameter input function.
No
Select parameter „105" by pressing the corresponding +/- key.
VAL
By pressing the corresponding +/- key set the number of stitches to be sewn with one
bobbin.
Conclude the parameter input by pressing the TE/Speed key. The value enter is stored.
2.5
TE
No
101
3
TE
No
105
To activate the stitch counting function, the value of parameter "104" must be set
at "1".
Shortly before the number of stitches entered have been sewn, the signal
"
WARNING 2" appears on the display after the thread has been trimmed, also
see Chapter 12.08 Warning signals.
To be able to continue sewing after the bobbin has been changed, the error
elimination must be acknowledged by pressing any key on the control panel.
2.5
VAL
II
VAL
100
Setting up
9 - 10
Advertisement
Table of Contents
