Setting up
9
Setting up
9
Inserting the needle
.01
9 - 1
All instructions and regulations in this instruction manual must be observed. Spe-
cial attention must be paid to all safety regulations!
All setting-up work must only be carried out by personnel with the appropriate
training. For all setting-up work the machine must be disconnected from its po-
wer supply by turning off the on/off switch, or removing the plug from the electric
power socket.
1
Fig. 9 - 01
The choice of needle depends on the model of the machine and the thread and
material used ( see Chapter 3.02 Needles and threads ).
Only use needles of system 134-35.
2
Raise the feed band 1.
Pull down feed band 1 a little and swing it
towards the left.
Loosen screw 2 and insert the needle as
far as possible. The long needle groove
must be facing towards the left.
Tighten screw 2 and swing the feed band
back into position.
Switch the machine off!
Danger of injury if the machine
is started accidentally!