Registering A Unit - Panasonic KX-TGH222AZ Operating Instructions Manual

Programming
5
Select a memory location by pressing 1
to 6. a MOKN
6
Enter the phone number or area code to
be restricted (8 digits max.). a MOKN a
M N
Enhancing security for phone
calls
You can increase the security of phone
conversations by setting this feature to
"Enhanced". When "Enhanced" is selected,
is displayed. The default setting is
"Normal".
1
MMENUN (right soft key) #729
2
MbN: Selected the desired setting. a MOKN
3
M N
Note:
R If you set repeater mode to "On"
(page 35):
– Security is set to "Normal" and
displayed.
– "Security" is not displayed in the
display menu (page 26).
R When enhanced security is enabled, sound
may cut in and out during conversations.
Changing the base unit PIN
Important:
R If you change the PIN (Personal
Identification Number), please make note of
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, contact
an authorised service centre.
1
MMENUN (right soft key) #132
2
Enter the current 4-digit base unit PIN
(default: "0000").
3
Enter the new 4-digit base unit PIN. a
MOKN
4
MbN: "Yes" a MOKN a M
34
TGH222_23AZ(en)_0314_ver101.pdf 34
Changing the unit's region
setting/Resetting the base unit
1
MMENUN (right soft key) #136
2
MbN: Select the desired country. a MOKN
"Australia" = Australia
"NewZealand" = New Zealand
3
MbN: "Yes" a MOKN a M
Note:
R Changing the unit's region setting may
cause the settings for your country or your
customised settings to return to their default
settings.

Registering a unit

Operating additional units
Additional handsets
is
Up to 6 handsets can be registered to the
base unit.
Important:
R The additional handset model
recommended for use with this unit is noted
on page 4. If another handset model is
used, certain operations may not be
available.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
near the base unit), re-register the handset.
1
Handset:
MMENUN (right soft key) #130
2
Base unit:
N
Press and hold MLOCATORN for about 5
seconds.
R If all registered handsets start ringing,
press MLOCATORN again to stop, then
repeat this step.
N
3/14/2014 10:01:16 AM