Table of Contents
Advertisement
Programming
Note:
R If you set repeater mode to "On"
(page 33):
– Security is set to "Normal" and
displayed.
– "Security" is not displayed in the
display menu (page 24).
R When enhanced security is enabled, sound
may cut in and out during conversations.
Changing the base unit PIN
Important:
R If you change the PIN (Personal
Identification Number), please make note of
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, contact
an authorised service centre.
1
MMENUN#132
2
Enter the current 4-digit base unit PIN
(default: "0000").
R If you forget your PIN, contact an
authorised service centre.
3
Enter the new 4-digit base unit PIN. a
MOKN
4
MbN: "Yes" a MOKN a MOFFN
Changing the unit's region
setting/Resetting the base unit
1
MMENUN#136
2
MbN: Select the desired country. a
MSELECTN
"Australia" = Australia
"NewZealand" = New Zealand
3
MbN: "Yes" a MSELECTN a MOFFN
Note:
R Changing the unit's region setting may
cause the settings for your country or your
customised settings to return to their default
settings.
32
Registering a unit
is
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R The additional handset model
recommended for use with this unit is noted
on page 4. If another handset model is
used, certain operations may not be
available.
Additional base units
Handsets can be registered to up to 4 base
units, allowing you to add additional base units
and extend the area in which your handset(s)
can be used. If a handset moves out of range
of its base unit when "Auto" is selected on
base unit (page 33), it looks for another
base unit to make or receive calls. A base unit
and the handsets it communicates with is
called a "radio cell".
Note:
R Calls are disconnected when the handset
moves from one radio cell to another.
Registering a handset to a base
unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
near the base unit), re-register the handset.
1
Handset:
MMENUN#130
2
MbN: Select a base unit number. a MOKN
R This number is used by the handset as
a reference only.
3
Base unit:
Press and hold M
R If all registered handsets start ringing,
press M
this step.
N for about 5 seconds.
N again to stop, then repeat
Advertisement
Table of Contents
