Baby Monitor - Panasonic KX-TGH222AZ Operating Instructions Manual

Blocking incoming calls that
have no phone number
You can reject calls when no phone number is
provided, such as private callers.
1
MMENUN (right soft key) #240
2
MbN: Select the desired setting. a MOKN
3
M N
Viewing/editing/erasing call
block numbers
1
MMENUN (right soft key) #217
2
MbN: "Single Number" or "Range of
Numbers" a MOKN
3
MbN: Select the desired entry.
R To exit, press M
4
To edit a number:
MEDITN a Edit the number. a MOKN a
M N
To erase a number:
MERASEN a MbN: "Yes" a MOKN a
M N
Note:
R When editing, press the desired dial key to
add, MCLEARN to erase.
Erasing all call block numbers
1
MMENUN (right soft key) #217
2
MbN: "Single Number" or "Range of
Numbers" a MOKN
3
MMENUN a MbN: "Erase All" a MOKN
4
MbN: "Yes" a MOKN
5
MbN: "Yes" a MOKN a M

Baby monitor

This feature allows you to listen in on a room
where another handset is located, allowing
you to easily monitor from different areas of
the house or place. The monitored handset
TGH222_23AZ(en)_0314_ver101.pdf 31
(placed in a baby's room, for example) will
automatically call the monitoring handset or
the phone number stored when it detects
sound.
Important:
R You should perform a test run of the baby
R This feature should not be used as a
Note:
R If the unit is connected to a PBX system,
N.
R During the monitoring mode, battery
R The monitored handset never rings during
Setting the baby monitor
Perform the setting operation with the handset
to be monitored (for example, the handset
placed in a baby's room).
To monitor with a handset
The internal baby monitor feature is only
available between handsets.
1
N
2
3
Programming
monitor procedure to ensure that the baby
monitor feature is set correctly. For
example, test its sensitivity. Check the
connection if you are diverting the baby
monitor to an outside line.
substitute for a medical or caregiver's
supervision. It is the caregiver's
responsibility to stay close enough to
handle any eventuality.
you cannot set the baby monitor.
consumption is faster than usual. We
recommend leaving the monitored handset
on the base unit or charger.
the monitoring mode. But if the monitored
handset is on the base unit, the base unit
ringer sounds. Turn off the base unit ringer
volume to not sound the ringer (page 25).
MMENUN (right soft key) #268
MbN: "On" a MOKN
MbN: Select the desired handset number
to monitor with. a MOKN
R "Baby Monitor" will be displayed.
R The registered handset name/number
is displayed.
31
3/14/2014 10:01:16 AM