Other Programming - Panasonic KX-TGH222AZ Operating Instructions Manual

R The monitoring handset will answer calls
automatically when the auto intercom
feature is set to "On" (page 17).
Note:
R If you receive an outside call when
communicating with the monitored
handset, you hear 2 tones. To answer
the call, press M
n When monitoring from an outside line:
To answer a call, follow the operation for
your phone.
If you want to respond from the monitoring
handset, press #1 using tone dialling.
You can turn off the baby monitor feature
by pressing #0.
Note:
R 2 minutes after the monitored handset
starts a call, communication between the
monitored handset and monitoring
phone line is turned off automatically.

Other programming

Changing the handset name
The default handset name is "Handset 1" to
"Handset 6". You can customise the name
of each handset ("Bob", "Kitchen", etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 33).
1
MMENUN (right soft key) #104
2
Enter the desired name (10 characters
max.).
3
MOKN a M N
Displaying the handset name
You can select whether or not the handset
name is displayed in standby mode. The
default setting is "Off".
1
MMENUN (right soft key) #105
2
MbN: Select the desired setting. a MOKN
a M N
TGH222_23AZ(en)_0314_ver101.pdf 33
Storing an area code to be
deleted automatically
In some situations, phone numbers stored
automatically in the caller list (page 37) will
include area codes. If you do not want to dial
the area code when making calls from the
caller list, you can store the area code which
N, then press M N.
you want the unit to delete automatically.
Example: You have stored the area code
"09". If you make a call from the caller list to
the phone number "09-456-7890", the unit
dials "456-7890".
1
2
Note for New Zealand:
R The use of this feature can prevent a
Call restriction
You can restrict selected handsets from
dialling certain numbers. You can assign up to
6 phone numbers to be restricted, and select
which handsets are to be restricted. Storing
area codes here prevents the restricted
handsets from dialling any phone number in
that area code.
1
2
3
4
Programming
MMENUN (right soft key) #255
Enter an area code (5 digits max.). a
MOKN a M N
National Call from being dialled. E.g., in the
case of the South Island, the "03" will be
omitted and will therefore prevent a
National Call to other areas of the South
Island.
MMENUN (right soft key) #256
Enter the base unit PIN (default: "0000").
R If you forget your PIN, contact an
authorised service centre.
Select the handsets to be restricted by
pressing 1 to 6.
R All handsets registered to the base unit
are displayed.
R " " is displayed next to the selected
handset numbers.
R To cancel a selected handset, press
the same dial key again. " "
disappears.
MOKN
33
3/14/2014 10:01:16 AM