Panasonic KX-TGH222AZ Operating Instructions Manual page 42

Answering System
setting is turned on. The default setting is
"Off".
1
MMENUN (right soft key) #339
2
MbN: Select the desired setting. a MOKN
a M N
New message alert by a call
This feature allows you to receive a
notification by phone when new messages are
recorded. The base unit calls a phone number
you specify. You can then operate the
answering system remotely to listen to the
new message.
To use this feature, you must:
– store a phone number to which the unit
makes the call to.
– turn on the new message alert setting.
After you answer the new message alert call,
you can listen to messages from that call
(page 43).
Important:
R A new message alert is stopped 1 minute
after the unit starts to call. The unit will not
retry the call even if the call is not answered.
Storing a phone number to which the
unit makes an alert call
n From the phonebook:
1
MMENUN (right soft key) #338
2
MbN: "Notification to" a MOKN
a MADDN
3
MbN: "Phonebook" a MOKN
4
MbN: Select the desired phonebook
entry. a MOKN 2 times a M
n By entering a phone number:
1
MMENUN (right soft key) #338
2
MbN: "Notification to" a MOKN
a MADDN
3
MbN: "Manual" a MOKN
4
Enter the desired name (16 characters
max.). a MOKN
5
Enter the desired number (24 digits
max.). a MOKN 2 times a M
42
TGH222_23AZ(en)_0314_ver101.pdf 42
Turning on/off the new message alert
setting
1
MMENUN (right soft key) #338
2
MbN: "On/Off" a MOKN
3
MbN: Select the desired setting. a MOKN
a M N
Editing the set phone number
1
MMENUN (right soft key) #338
2
MbN: "Notification to" a MOKN
3
MMENUN a MbN: "Edit" a MOKN
4
Edit the name if necessary (16 characters
max.). a MOKN
5
Edit the phone number if necessary (24
digits max.). a MOKN 2 times a M
Erasing the set phone number
1
MMENUN (right soft key) #338
2
MbN: "Notification to" a MOKN
3
MMENUN a MbN: "Erase" a MOKN
4
MbN: "Yes" a MOKN a M
R The new message alert setting is
turned off.
Activating/inactivating the remote
access code to play messages
If you activate this feature, you must enter the
remote access code (page 43) to play the
new message from the new message alert
call. This is so that unauthorised parties
cannot listen to your messages. The default
N
setting is "Inactivate".
– "Inactivate": You can listen to the
message by pressing 4 to play new
messages (without entering the remote
access code).
– "Activate": You must enter your remote
access code and then press 4 to play new
message.
1
MMENUN (right soft key) #338
2
MbN: "Remote Code" a MOKN
N
N
N
3/14/2014 10:01:17 AM