Nuisance Call Block - Panasonic KX-TGH222AZ Operating Instructions Manual

Digital cordless answering system
Hide thumbs Also See for KX-TGH222AZ:
Table of Contents

Advertisement

Programming
4
Enter the desired hour and minute you
wish to end this feature. a MOKN a
M
N
Changing the start and end time
1
MMENUN (right soft key) #237
2
Continue from step 3, "Turning do not
disturb mode on/off", page 29.
Setting the ring delay
This setting allows the handset to ring during
do not disturb mode if the caller waits long
enough. After the selected amount of time
passes, the handset rings. If you select "No
Ringing", the handset never rings during do
not disturb mode.
1
MMENUN (right soft key) #239
2
MbN: Select the desired setting. a MOKN
a M
N
Note:
R When the answering system answers the
call, this feature does not work.
Selecting categories to bypass do
not disturb mode
1
MMENUN (right soft key) #241
2
Select your desired categories by
pressing 1 to 9.
R " " is displayed next to the selected
category numbers.
R To cancel a selected category, press
the same dial key again. " "
disappears.
3
MOKN a M
N

Nuisance call block

This feature rejects calls from unwanted
callers (Caller ID subscribers only). The
following items are available when storing
phone numbers in the call block list (50 max.).
– "Single Number": The unit can reject
calls from specific phone numbers.
30
TGH222_23AZ(en)_0314_ver101.pdf 30
– "Range of Numbers": The unit can
reject calls that begin with a number stored
in the call block list, such as a toll-free
phone number prefix or certain area codes.
You can also set the unit to reject calls that do
not have a phone number.
When a call is received, the unit does not ring
while the caller is being identified. If the
caller's phone number matches an entry in the
call block list, the unit emits no sound to the
caller, and disconnects the call.
Important:
R Rejected calls are logged in the caller list.
Storing unwanted callers
Storing a single phone number
Important:
R You must include the area code when
storing phone numbers in the call block list.
n From the caller list:
1
M N
2
MbN: Select the entry to be blocked. a
MMENUN
3
MbN: "Save Caller ID" a MOKN
4
MbN: "Nuisance Call Block" a MOKN
5
MbN: "Yes" a MOKN a M
n By entering phone numbers:
1
MMENUN (right soft key) #217
2
MbN: "Single Number" a MOKN
3
MMENUN a MbN: "Add" a MOKN
4
Enter the phone number (24 digits max.).
R To erase a digit, press MCLEARN.
5
MOKN a M
N
Storing a range of numbers
1
MMENUN (right soft key) #217
2
MbN: "Range of Numbers" a MOKN
3
MMENUN a MbN: "Add" a MOKN
4
Enter the desired number (2-8 digits).
R To erase a digit, press MCLEARN.
5
MOKN a M
N
N
3/14/2014 10:01:16 AM

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kx-tgh223az

Table of Contents