Intercom; Key Lock; Power Back-Up Operation - Panasonic KX-TGH222AZ Operating Instructions Manual

R To put the outside call on hold:
MMENUN a MbN: "Hold" a MOKN
To resume the conference: MMENUN
a MbN: "Conference" a MOKN
R To cancel the conference: MMENUN a
MbN: "Stop Conference" a MOKN
You can continue the conversation
with the outside caller.

Intercom

Intercom calls can be made between
handsets.
Note:
R When paging the handset, the paged
handset beeps for 1 minute.
R If you receive an outside call while talking
on the intercom, you hear 2 tones. To
answer the call, press M
M N.
Making an intercom call
1
MMENUN (right soft key) a MINTERCOMN
2
MbN: Select the desired unit. a MOKN
3
When you finish talking, press M
Answering an intercom call
1
Press M N to answer the page.
2
When you finish talking, press M
Using the Smart Function Key
Press M N to answer the page.
Turning auto intercom on/off
This feature allows the handset to answer
intercom calls automatically when it is called.
You do not need to press M
feature is set to "On", the monitoring handset
for the baby monitor feature (page 33) will
also answer baby monitor calls automatically.
The default setting is "Off".
TGH222_23AZ(en)_0314_ver101.pdf 17
1
MMENUN (right soft key) #273
2
MbN: Select the desired setting. a MOKN
a M

Key lock

The handset can be locked so that no calls or
settings can be made. Incoming calls can be
answered, but all other functions are disabled
while key lock is on.
To turn key lock on, press MMENUN (right soft
key) for about 3 seconds.
R To turn key lock off, press M
key) for about 3 seconds.
Note:
R Calls to emergency numbers cannot be
made until key lock is turned off.
N, then press

Power back-up operation

When a power failure occurs, the charged
handset temporarily supplies power to the
base unit (power back-up mode). This allows
you to make and receive calls using a handset
during a power failure. The base unit will not
N.
perform any other functions. You can program
"Power Failure" and the default setting is
"Auto" (page 27).
Important:
R If a handset is not placed on the base unit
N.
when a power failure occurs, "Base no
power Press
pressing M
the base unit to start power back-up mode.
R Power back-up mode will not work if the
battery level of the power supplying
handset is
R Do not lift the power supplying handset
from the base unit during power back-up
mode.
N. When this
Making/Answering Calls
N
N (right soft
" is displayed. After
N on the handset, place it on
/ .
3/14/2014 10:01:16 AM
17