Motorola AP7131 Installation Manual page 21

Installation Guide
For Motorola Power Injector installations:
a. Connect an RJ-45 CAT5 Ethernet cable between the network data supply (host) and the Power
Injector's Data In connector.
b. Connect an RJ-45 CAT5 Ethernet cable between the Power Injector's Data & Power Out connector
and the Access Point's GE1/POE port.
c. Ensure the cable length from the Ethernet source (host) to the Power Injector and Access Point does
not exceed 100 meters (333 ft). The Power Injector has no On/Off power switch. The Power Injector
receives power as soon as AC power is applied. For more information, see
For standard power adapter (non Power Injector) and line cord installations:
a. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the network data supply (host) and the
Access Point's GE1/PoE or GE2 port.
b. Verify the power adapter is correctly rated according the country of operation.
c. Connect the power supply line cord to the power adapter.
d. Attach the power adapter cable into the power connector on the Access Point.
e. Attach the power supply line cord to a power supply.
CAUTION
15. Verify the behavior of the Access Point LED light pipe. For more information, see
LED Indicators.
16. Place the ceiling tile back in its frame and verify it is secure.
17. The Access Point is ready to configure. For information on basic Access Point device configuration, see
Basic Access Point Configuration
Do not actually connect to the power source until the cabling portion
of the installation is complete
.
Power Injector System
21
.