Motorola AP7131 Installation Manual page 18

18
e. Attach the power supply line cord to a power supply.
CAUTION
5. Verify the behavior of the Access Point LEDs. For more information, see
6. Align the bottom of the ceiling T-bar with the back of the Access Point.
7. Orient the Access Point chassis by its length and the length of the ceiling T-bar.
8. Rotate the Access point chassis 45 degrees clockwise.
9. Push the back of the Access Point chassis on to the bottom of the ceiling T-bar.
10. Rotate the Access Point chassis 45 degrees counter-clockwise. The clips click as they fasten to the T-bar.
11. The Access Point is ready to configure. For information on basic Access Point device configuration, see
Basic Access Point Configuration
Do not actually connect to the power source until the cabling portion
of the installation is complete
.
AP-7131 Access Point
LED Indicators
.