Motorola AP7131 Installation Manual page 15

Hide thumbs Also See for AP7131:
Table of Contents

Advertisement

Installation Guide
To mount the Access Point on a wall using the provided template:
1. Copy the template (on the previous page) to a blank piece of paper. Do not reduce or enlarge the scale of
the template.
NOTE
2. Tape the template to the wall mounting surface.
• If the installation requires the antenna be positioned vertically, the centerline reference (of the
template) needs to be positioned vertically. The cabling shall exit the Access Point in a vertical
direction.
• If the installation requires the antenna be positioned horizontally, the vertical centerline (of the
template) needs to be positioned horizontally. The cabling shall exit the Access Point in a horizontal
direction
3. At mounting targets A and B, mark the mounting surface through the template at the target center.
4. Discard the mounting template.
5. At each point, drill a hole in the wall, insert an anchor, screw into the anchor the wall mounting screw and
stop when there is 1mm between the screw head and the wall.
6. If pre-drilling a hole, the recommended hole size is 2.8mm (0.11in.) if the screws are going directly into
the wall and 6mm (0.23in.) if wall anchors are being used.
7. If required, install and attach a security cable to the Access Point lock port.
8. Attach the antennas to their correct connectors.
For information on available antennas, see
9. Place the large center opening of each of the mount slots over the screw heads.
10. Slide the Access Point down along the mounting surface to hang the mount slots on the screw heads.
CAUTION
NOTE
11. Cable the Access Point using either the Power Injector solution or an approved line cord and power supply.
If printing the mounting template (on the previous page) from an
electronic PDF, dimensionally confirm the template by measuring each
value for accuracy.
Ensure you are placing the antennas on the correct connectors
(depending on your single or dual-radio model and frequency used) to
ensure the successful operation of the Access Point.
It is recommended the Access Point be mounted with the RJ45 cable
connector oriented upwards or downwards to ensure proper operation.
Antenna Options
.
15
.

Advertisement

Table of Contents
loading

Table of Contents