Motorola AP7131 Installation Manual page 20

20
6. Use a drill to make a hole in the tile the approximate size of the Access Point LED light pipe.
CAUTION
7. Remove the light pipe's rubber stopper (from the Access Point) before installing the light pipe.
8. Connect the light pipe to the bottom of the Access Point. Align the tabs and rotate approximately 90
degrees. Do not over tighten.
9. Fit the light pipe into hole in the tile from its unfinished side.
10. Place the decal on the back of the badge and slide the badge onto the light pipe from the finished side of
the tile.
11. Attach the antennas to their correct connectors.
CAUTION
For information on the antennas available to the Access Point, see
12. Motorola Solutions recommends attaching safety wire to the Access Point safety wire tie point or security
cable (if used) to the Access Point's lock port.
13. Align the ceiling tile into its former ceiling space.
14. Cable the Access Point using either the Power Injector solution or an approved line cord and power supply.
Motorola Solutions recommends care be taken not to damage the
finished surface of the ceiling tile when creating the light pipe hole
and installing the light pipe.
Ensure you are placing the antennas on the correct connectors
(depending on your single or dual-radio model and frequency used) to
ensure the successful operation of the Access Point.
AP-7131 Access Point
Antenna Options
.