Motorola AP7131 Installation Manual page 16

16
For Motorola Power Injector installations:
a. Connect an RJ-45 CAT5 Ethernet cable between the network data supply (host) and the Power
Injector's Data In connector.
b. Connect an RJ-45 CAT5 Ethernet cable between the Power Injector's Data & Power Out connector
and the Access Point's GE1/POE ports.
Ensure the cable length from the Ethernet source (host) to the Power Injector and Access Point does
c.
not exceed 100 meters (333 ft). The Power Injector has no On/Off power switch. The Power Injector
receives power as soon as AC power is applied. For more information, see
For standard power adapter (non Power Injector) and line cord installations:
a. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the network data supply (host) and the
Access Point's GE1/PoE.
b. Verify the power adapter is correctly rated according the country of operation.
c. Connect the power supply line cord to the power adapter.
d. Attach the power adapter cable to the DC-48V power connector on the Access Point.
e. Attach the power supply line cord to a power supply.
12. Verify the behavior of the Access Point LEDs. For more information, see
CAUTION
13. The Access Point is ready to configure. For information on basic Access Point device configuration, see
Basic Access Point
Do not actually connect to the power source until the cabling portion
of the installation is complete
Configuration.
AP-7131 Access Point
Power Injector
LED Indicators
.
System.