Table of Contents
Advertisement
Tap the <Up/Down>button until the display will show "Status".
l
Press ENTER, the display will show "Status".
l
2．Press <Up/Down>, the display will show "Hibernation".
3．Press< ENTER>, the display will show "Hibernation".
4．The display show "15M",Press <Up/Down>, the display will show "01M"， "02M" .... "99M" or"OFF".
5．Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
Service PIN
Service PIN——The Password for this function is "50".
RDM PID—— With this function you can recall various menu items via RDM.
This device is RDM ready. RDM stands for "remote device management" and makes remote control of devices connected to the
DMX-bus. ANSI E1.20-2006 by ESTA specifies the RDM standard as an extension of the DMX512 protocol.
Manual settings like adjusting the DMX starting address are no longer needed. This is especially useful when the device is installed in
a remote area.
RDM ready and conventional DMX devices can be operated in one DMX line. The RDM protocol sends own packages in the
DMX512 data feed and does not influence conventional devices.
If DMX splitters are used and RDM control is to be used, these splitters must support RDM.
The number and type of RDM parameters depend on the RDM controller being used.
Disp.Setting
Shutoff Time
With this function you can shut off the color LCD display after 2 to 60 minutes. Turn the encoder in order to select the desired shut off
time. The default is 2 minute.
Flip Display
With this function you can rotate the display by 180°.
1．Tap <MODE/ESC>button， access the main menu，
Tap the <Up/Down>button until"Set"is displayed.
l
Press ENTER, the display will show "Set".
l
2. Tap the <Up/Down>button until the display will show "Disp.Setting".
3. Press ENTER, the display will show "Disp.Setting".
2．Press <Up/Down>, the display will show "Flip Display".
3．Press< ENTER>, the display will show "Flip Display".
4．The display show "OFF",Press <Up/Down>, the display will show "ON".
5．Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
Key Lock
With this function you can activate the automatic keylock status. If this function is activated, the keys will be locked automatically after
exiting the edit mode for 15 seconds. keeping press the<MODE/ESC> key for 3seconds if you do not need this function.
1．Tap <MODE/ESC>button， access the main menu，
31
Advertisement
Table of Contents
