Page 1
PA BOARD ..... . . LBI-39051 SERVICE SECTION ....LBI-39018 Ericsson Inc. Private Radio Systems...
Page 2
-45 dB (maximum) rors, inaccuracies of current information, or improvements to programs and/or equipment, may be made by Ericsson Inc., at any time and with- out notice. Such changes will be incorporated into new editions of this manual. No part of this manual may be reproduced or transmitted in any...
LBI-39014A Continued Continued SPECIFICATIONS* ENVIRONMENTAL RECEIVER STANDARD METHODS PROCEDURES Frequency Range Low Split Radio 403 to 440 MHz Mil-810C Mil-810D Mil-810E Mid Split Radio 440 to 470 MHz High Temperature 501.1/Proc 2 501.2/Proc 2 501.3/Proc 2 High Split Radio 470 to 512 MHz Low Temperature 502.1/Proc 2 502.2/Proc 2...
Display Board for the alphanumeric LED dis- play. The synthesizer circuit generates all transmit and receive The Ericsson GE UHF MDX™ Mobile Radio is a synthe- Carrier Control Timer (CCT) RF frequencies. The synthesizer frequency is controlled by the sized, wide band radio that uses integrated circuits and micro- microprocessor located on the Audio/Logic Board.
(19A705499P1) can sound the vehicle horn when a call is re- NOTE: ceived. The option connects to Pin 13 of cable option Primary codes in bold are unique Ericsson codes. RECEIVER SCAN RATE PMCD7Z (19C851585P14) and is enabled through the front Squelch Tail Elimination (STE) panel switch.
Page 6
LBI-39014A Scan operation will be determined by the following condi- Press the programmed flex key mapped to scan DELETE SCAN CHANNEL (S, P1, P2) DISPLAY tions: add/delete to add the channel to the scan list. The S indicator will be shown in the display to indicate that Confirm that the radio is on.
LBI-39014A MONITOR (CLR) SWITCH OPERATION IN time is normally 2 seconds in length and PC pro- grammable from 0.3 to 5 seconds on 0.1 seconds SCAN steps. If no other channel activity occurs during this time, scanning will then resume. The priority chan- The CLR switch does not operate while scanning inac- nels are still being sampled during the hang time.
LBI-39014A Priority 1 Channel Programming: than or equal to four, then all non-priority channels will be Carrier on P2 detected/wrong Channel Guard CONDITION 3: P2 has Channel Guard, P1 does not scanned between each P1, P2 scan. P1-P2-P1-P1-P1-P1-P1-P1-P1-P1-P1-P2-P1... • Method 1 - Front programmable (default) tb=500 msec No carriers detected on P1 or P2 As an added example, consider channels 1-8 to be scanned...
787.5 Hz When a T99 call is received, the entire display will alter- 823.5 Hz Tone D is the diagonal tone used (Ericsson GE tone sys- nate between "T99" and the normal channel display and an 877.5 Hz In the Ericsson GE tone format, the first tone may be tems only) when the first and second tone frequencies are the alert tone will sound.
Page 10
LBI-39014A In the Motorola tone format, the first tone may be one to Table 5 - Motorola Type Coder Numbers Table 6 - Motorola Tone Frequencies and Groups three tones: A for individual call, B for Quick-Call and C for Group Call.