Table of Contents
Advertisement
METHOD 3: Returning the Microphone to the hang-up bracket (enabled
If a channel disconnect occurs before the conversation ended, the call
must be initiated again. To avoid confusion it is recommended that a
procedure be set up so that the originator of the call is the one designated
to re-establish communications. Two or more operators originating a
call simultaneously may acquire two different channels making
communication impossible.
MOBILE DATA TERMINAL INTERFACE (OPTIONAL)
Your MDX radio is capable of interfacing with a Mobile Data Termi-
nal/Computer Host. When placing or receiving data calls, the MDX displays
"DATACALL". When "DATACALL" is present, voice calls are disabled. You
will miss all voice calls made to the radio when data is being exchanged.
Optional interface cables are required when operating with the Mobile
Data Terminal/Computer Host.
You can stop transmission and reception of data using any of the following
methods:
1. Remove the microphone from the hookswitch.
2. Hold the CLR button and press PTT. A high pitched beep will be
heard. Release the CLR button.
3. Declaring an Emergency (not to be used unless an actual emergency
condition exists).
4. A group or system change.
When in the no-data mode, the radio displays "*NO DATA". This will
remain displayed until the no-data mode is cleared by one of the following
(depending on how it was activated):
1. Replace the microphone into the hookswitch.
2. Repeat the CLR-PTT sequence.
3. Use the CLR-PTT sequence during the emergency to enable data.
28
through programming).
NOTE
NOTE
Advertisement
Table of Contents
