Battery Service; Battery Replacement - Westinghouse WH3250 series Owner's Manual

Hide thumbs Also See for WH3250 series:
Table of Contents

Advertisement

Available languages

Available languages

8. Install the spark plug by carefully following the steps
outlined below:
a -
Carefully insert the spark plug back into the
cylinder head. Hand-thread the spark plug until
it bottoms out.
b -
Using the 13/16" spark plug socket wrench
provided, turn the spark plug to ensure it is fully
seated.
c -
Replace the spark plug boot, making sure the
boot fully engages the spark plug's tip.
Recommended Spark Plug Replacement:
AutoLite
Champion
Bosch
Torch

BATTERY SERVICE

To ensure the battery remains charged, the generator
should be started every 2 to 3 months and run for a
minimum of 15 minutes. If the generator is stored more
than a year without running, a battery charger may be
needed to recharge the battery.

Battery Replacement

1. Remove the spark plug wire from spark plug.
63
RN9YC
WR7DS
F6RTC
MAINTENANCE
2. Loosen and remove the nuts on the battery hold-
down plate and remove the plate from the support
rods (see Figure 39).
2
3
Figure 39
1 - Nuts
2 - Battery Hold-
Down Plate
3. Tip the battery forward slightly to access battery
cables.
4. Disconnect the black negative (-) battery cable from
the battery first.
5. Disconnect the red positive (+) battery cable
second and remove the battery.
1
3 - Support Rods
33

Advertisement

Chapters

Table of Contents
loading

Table of Contents