Battery Service; Battery Replacement - Westinghouse 10KPRO Owner's Manual

MAINTENANCE
8. Install the spark plug by carefully following the steps
outlined below:
a - Carefully insert the spark plug back into the
cylinder head. Hand-thread the spark plug until
it bottoms out.
b - Using the 13/16" spark plug socket wrench
provided, turn the spark plug to ensure it is fully
seated.
c - Replace the spark plug boot, making sure the
boot fully engages the spark plug's tip.
Recommended Spark Plug Replacement:
AutoLite
Champion
Bosch
Torch

BATTERY SERVICE

To ensure the battery remains charged, the generator
should be started every 2 to 3 months and run for
a minimum of 15 minutes or the charger should be
plugged into the generator and the generator should be
charged overnight. Plug the cord from the charger into
the charging port on the generator. Plug the charger into
a 110/120-volt AC outlet (see Figure
Figure 33 – 120-Volt AC Charger
30
63
RN9YC
WR7DS
F6RTC
33).

Battery Replacement

1. Remove the spark plug wire from spark plug.
2. Loosen and remove the nuts on the battery hold-
down plate and remove the plate from the support
rods (see Figure 34).
2
3
Figure 34
1 - Nuts
2 - Battery Hold-
Down Plate
3. Tip the battery forward slightly to access battery
cables.
4. Disconnect the black negative (-) battery cable from
the battery first.
5. Disconnect the red positive (+) battery cable
second and remove the battery.
1
3 - Support Rods