Westinghouse WH3250 series Owner's Manual page 24

OPERATION
2. Move the fuel shutoff valve to the ON position (see
Figure 17).
Figure 17 – Fuel Shutoff Valve in the ON Position
3. Move the choke lever to the ON position (see
Figure 18).
Figure 18 – Choke Lever
24
4. Push the engine control switch into the RUN
position (see Figure 19).
Figure 19 – Engine Control Switch
5. Firmly grasp and pull the recoil handle slowly until
you feel increased resistance. At this point, apply a
rapid pull while pulling up and slightly away from the
generator (see Figure 20).
Figure 20
6. As the engine starts and stabilizes, gradually move
the choke lever back to the OFF position.