Yamaha RX-V781 Owner's Manual page 56

⬛
Using other connection methods
If your wireless router (access point) does not support WPS push button
configuration method, follow the procedure below to configure the
z
wireless network settings.
1
Press z (receiver power) to turn on the unit.
2
Turn on the TV and switch the TV input to display video
from the unit (HDMI OUT jack).
Y
Operations with TV screen are available only when your TV is connected to the
unit via HDMI.
3
Press ON SCREEN.
ON SCREEN
4
Use the Cursor keys to select "Setup" and press ENTER.
Cursor keys
ENTER
5
Use the Cursor keys (e/r) to select "Network".
6
Use the Cursor keys (q/w) to select "Network
Connection" and press ENTER.
7
Use the Cursor keys (q/w) and ENTER to check "Wireless
(Wi-Fi)" and select "OK".
X
The checkmark indicates the current setting.
8
Use the Cursor keys (q/w) and ENTER to select the
desired connection method and select "NEXT".
The following connection methods are available.
WPS Button
Share Wi-Fi
Settings (iOS)
Access Point Scan
Manual Setting
PIN Code
About WPS
WPS (Wi-Fi Protected Setup) is a standard established by the Wi-Fi Alliance,
which allows easy establishment of a wireless home network.
56
En
You can set up a wireless connection with the WPS
button while viewing the TV screen. Follow the
instructions displayed on the TV screen.
See "Sharing the iOS device setting" (p.54).
You can set up a wireless connection by searching for
an access point. For details on settings, see
"Searching for an access point" (p.57).
You can set up a wireless connection by entering the
required information (such as SSID)
manually. For details on settings, see "Setting up the
wireless connection manually" (p.57).
You can set up a wireless connection by entering the
unit's PIN code into the wireless router (access
point). The method is available if the wireless router
(access point) supports the WPS PIN code method.
For details on settings, see "Using the PIN code"
(p.58).