Voice Recognition Learning Function (Speaker Enrollment) (Type A); When Voice Recognition Learning Is Done For The First Time; Voice Recognition Re-Learning - Mazda cx-5 2016 Manual

Interior Features
Bluetooth®
1. Press the pick-up button or talk button
with a short press.
2. Say: [Beep] Setup
3. Prompt: Select one of the following:
Pairing options, confirmation prompts,
language,passcode, select phone or
select music player.
4. Say: [Beep] Confirmation prompts
5. Prompt: Confirmation prompts are
on/off. Would you like to turn
confirmation prompts off/on?
6. Say: [Beep] Yes
7. Prompt: Confirmation prompts are
off/on.
qVoice Recognition Learning Function
(Speaker Enrollment) (Type A)
The voice recognition learning function
enables voice recognition appropriate to
the characteristics of the user's voice. If
the recognition of the voice input
commands to the system is not adequate,
this function can largely improve the
system's voice recognition of the user. If
your voice can be recognized sufficiently
without using this function, you may not
realize the added benefit of the function.
To register your voice, the voice input
command list must be read out. Read out
the list when the vehicle is parked.
Perform the registration in as quiet a place
as possible (page 5-81). The registration
must be performed completely. The
required time is a few minutes. The user
needs to be seated in the driver's seat with
the voice input command list for voice
recognition learning visible.
5-84
When voice recognition learning is
done for the first time
1. Press the pick-up button or talk button
with a short press.
2. Say: [Beep] Voice training
3. Prompt: This operation must be
performed in a quiet environment while
the vehicle is stopped. See the owner's
manual for the list of required training
phrases. Press and release the talk
button when you are ready to begin.
Press the hang-up button to cancel at
any time.
4. Press the talk button with a short press.
5. The voice guidance reads out the voice
input command number (refer to the
voice input command list for voice
recognition learning). (Ex. Please read
phrase 1 )
6. Say: [Beep] 0123456789 (Say the
voice input command for voice
recognition learning (1 to 8) according
to the voice guidance.)
7. Prompt: Speaker enrollment is
complete.
NOTE
If an error occurred in the voice recognition
learning, re-learning can be done by pressing
the talk button with a short press.

Voice recognition re-learning

If voice recognition learning has already
been done.
1. Press the pick-up button or talk button
with a short press.
2. Say:[Beep] Voice training