Replacing Exterior Light Bulbs; Headlights (With Led Headlights) Replacement; Headlights (With Halogen Headlights) Replacement; Low-Beam Bulbs, High-Beam Bulbs/Daytime Running Lights Replacement - Mazda cx-5 2016 Manual

Table of Contents

Advertisement

WARNING
Never touch the glass portion of a
halogen bulb with your bare hands and
always wear eye protection when
handling or working around the bulbs:
When a halogen bulb breaks, it is
dangerous. These bulbs contain
pressurized gas. If one is broken, it
will explode and serious injuries
could be caused by the flying glass.
If the glass portion is touched with
bare hands, body oil could cause the
bulb to overheat and explode when
lit.
Always keep halogen bulbs out of the
reach of children:
Playing with a halogen bulb is
dangerous. Serious injuries could be
caused by dropping a halogen bulb
or breaking it some other way.
CAUTION
When removing the lens or lamp unit
using a flathead screwdriver, make
sure that the flathead screwdriver
does not contact the interior
terminal. If the flathead screwdriver
contacts the terminal, a short circuit
may occur.
NOTE
To replace the bulb, contact an Authorized
l
Mazda Dealer.
If the halogen bulb is accidentally touched,
l
it should be cleaned with rubbing alcohol
before being used.
Use the protective cover and carton for the
l
replacement bulb to dispose of the old bulb
promptly and out of the reach of children.
Owner Maintenance
qReplacing Exterior Light Bulbs
Headlights (With LED headlights)
Low-beam bulbs, High-beam bulbs,
Daytime running lights/Parking lights
The LED bulb cannot be replaced as a
single unit because it is an integrated unit.
The LED bulb has to be replaced with the
unit. We recommend an Authorized
Mazda Dealer when the replacement is
necessary.
Headlights (With halogen headlights)
Low-beam bulbs, High-beam bulbs/
Daytime running lights
1. Make sure the ignition is switched off,
and the headlight switch is off.
2. Lift the hood.
3. (Right side)
Remove the windshield washer fluid
reservoir from the guide.
Guide
4. Disconnect the connector from the unit
by pressing the tab on the connector
with your finger and pulling the
connector downward.
Maintenance and Care
Windshield washer
fluid reservoir
6-49

Advertisement

Table of Contents
loading

Table of Contents