Data Is Being Lost; There Are Garbage Characters On The Monitor; The Modem Doesn't Work With Caller Id; Fax And Data Software Can't Run At The Same Time - Multitech MultiModem MT5634ZBA-V-V92 User Manual

Data Is Being Lost

•
If you are using data compression and a high speed serial port, set the serial port baud rate to two to six times
the data rate.
•
Make sure the flow control method you selected in software matches the method selected in the modem.
•
Try entering the I11 command or the &V command in command mode to display information about the last
connection, making a screen print of the connection statistics, and checking for parameters that might be
unacceptable.

There Are Garbage Characters on the Monitor

•
Your computer and the remote computer might be set to different word lengths, stop bits, or parities. If you have
connected at 8-N-1, try changing to 7-E-1, or vice-versa, using your communication software.
•
You might be experiencing line noise. Enable error correction, if it is disabled, or hang up and call again; you
might get a better connection the second time.
•
At speeds above 2400 bps, the remote modem might not use the same transmission or error correction
standards as your modem. Try connecting at a slower speed or disabling error correction. (With no error
correction, however, line noise can cause garbage characters.)
•
Try entering the I11 command or the &V command in command mode to display information about the last
connection, making a screen print of the connection statistics, and checking for parameters that might be
unacceptable.

The Modem Doesn't Work with Caller ID

•
Caller ID information is transmitted between the first and second rings, so if autoanswer is turned off (S0=0) or if
the modem is set to answer after only one ring (S0=1), the modem will not receive Caller ID information. Check
your initialization string, and if necessary change it to set the modem to answer after the second ring (S0=2).
•
Make sure that you have Caller ID service from your telephone company.
NOTE: The modem supports US Bellcore standard caller ID only.
Fax and Data Software Can't Run at the Same
Time
•
Communication devices can be accessed by only one application at a time. In Windows 2000 and higher, you
can have data and fax communication applications open at the same time, but they cannot use the same
modem at the same time.
Multi-Tech Systems, Inc. MT5634ZBA-Series User Guide (S000286G)
Chapter 7 – Troubleshooting
27