Tekno RC EB48.3 Building Instructions page 9

Bag G Bag G
Rear Hub/CVA Assembly Rear Hub/CVA Assembly
Step Step
G-1 G-1
Step Step
G-2 G-2
x4
TKR1201
M3 Locknut Black
x4
TKR1601
M3x4mm Set Screw
x2
TKR1603
M5x4mm Set Screw
x2
TKR5071X
M3x16.8mm Pin
x2
TKR5073
CV Joint Pin
x2
TKRBB08165
Ball Bearing (8x16x5)
x2
TKRBB13194
Ball Bearing (13x19x4)
TKR5072 TKR5072
TKR5073 TKR5073
Grease Grease
Changes to the wheelbase have a dramatic effect on handling,
since it shifts the disribution of weight over the rear wheels.
This adjusts traction. By shortening the wheelbase at the rear, you
are placing more weight over the rear wheels.
Changes to the wheelbase also change the amount of sweep the
rear driveshaft will have. More driveshaft sweep creates an effect
similar to anti-squat, where the rear end gets pushed upwards on
throttle. This helps reduce chassis slap when landing jumps on throttle.
TKR5073 TKR5073
TKR5070 TKR5070
TKRBB13194
TKRBB08165
TKR1201 TKR1201
(FRONT)
(REAR)
Note: Notch on pin
needs to line up
with set screw.
TKR5199
(Option)
*TKR5199A
TKR5071X
(Option)
*TKR5071B
*TKR5071C
Thread
TKR1603
TKR120 TKR1201
TKR5034 TKR5034
TKR51 TKR5165
TKR1601 TKR1601
TKR5165 TKR5165
9
Lock
1
165