Tekno RC EB48.3 Building Instructions page 8

Bag F Bag F
Rear End Rear End
Step
F-1
Step
F-2
TKR1327
TKR5163 TKR5163
x2
TKR1238
M4x10mm Droop Screw
x2
TKR1327
M3x16mm Flat Head Screw
TKR1333
M3x40mm Flat Head Screw
x4
TKR1402
M3x8mm Button Head Screw
x2
TKR1522
M3x8mm Cap Head Screw
x2
TKR1529
M3x20mm Cap Head Screw
x6
TKR1601
M3x4mm Set Screw
x2
TKR5049A
Pivot Ball Sway Bar
x2
TKR5079A
Stabilizer Ball
TKR5491 - 2.4mm TKR5491 - 2.4mm
*TKR5490 - 2.3mm *TKR5490 - 2.3mm
*TKR5492 - 2.5mm *TKR5492 - 2.5mm
*TKR5493 - 2.6mm *TKR5493 - 2.6mm
*TKR5494 - 2.8mm *TKR5494 - 2.8mm
*TKR5495 - 3.0mm *TKR5495 - 3.0mm
(Option) (Option)
30.2 30.2
TKR1601 TKR1601
Thread
Lock
TKR5165
TKR5049A TKR5049A
Step
F-3
x2
T T KR5174 TKR5174
Use a #19 drill bit or
4mm reamer to ream
arms until hinge pin
falls through freely.
T T KR1601 TKR1601
N N ote: Do not over-tighten Note: Do not over-tighten
TKR1601 TKR1601
TKR5086 TKR5086
TKR5079A TKR5079A
TKR1238
TKR1402 TKR1402
TKR5086 TKR5086
I Install the sway bar ball onto the nstall the sway bar ball onto the
sway bar wire until the end of sway bar wire until the end of
Thread
t the wire is flush with the ball as the wire is flush with the ball as
Lock
picture above. picture above.
("C" Block) ("C" Bl k) ("C" Block)
Stock Position Stock Position
TKR1522 TKR1522
TKR1601 TKR1601
Note: Loos Note: Loosen the M3x4 set screw (TKR1601) sen the M3x4 set screw (TKR1601)
if if the anti-roll bar does not turn freely. the an nti-roll bar does not
("D" Block) ("D" Block)
Stock Positio Stock Position
Note: With these stock
center dot settings,
Anti-Squat = 2° / Rear Toe = 3°
TKR5165 TKR5165
TKR5020
TKR5184 TKR5184
TKR1529
turn freely.
on
TKR1333 TKR1333
TKR TKR5164 5164
8