Tekno RC EB48.3 Building Instructions page 15

Bag K
Front End Assembly
Step Step
K-1 K-1
Step Step
K-3 K-3
Note: Inititial bumpsteer setting is four Note: Inititial bumpsteer setting is fo o ur
washers above the steering ball link. washers above the steering ball lin n k.
x2
TKR1201
M3 Lock Nut Black
x8
TKR1221
M3x8mm Washer
x1
TKR1323
M3x10mm Flat Head Screw
x2
TKR1343
M4x10mm Flat Head Screw
x6
TKR1344
M4x12mm Flat Head Screw
x5
TKR1443
M4x10mm Button Head Screw
x1
TKR1522
M3x8mm Cap Head Screw
x2
TKR1529
M3x20mm Cap Head Screw
Step Step
TKR5181 TKR5181
TKR5107 TKR5107
TKR1323 TKR1323
Step Step
K-4 K-4
TKR1522 TKR1522
TKR5166 TKR5166
TKR1344 TKR1344 TKR1344
TKR1443 TKR1443
K-2 K-2
TKR5102A TKR5102A
TKR1443 TKR1443
TKR1201 TKR1201
TKR1343 TKR1343
Thread Thread
Lock Lock
Note Step K-2: Note Step K-2:
Line up the bottom of the Line up the bottom of the
steering posts (TKR5102A) steering posts (TKR5102A)
with the corresponding with the corresponding
recessed cut in the chassis. recessed cut in the chassis.
Note: On steps K-2 Note: On steps K-2, K-3 and K-4 Do not
tighten the tighten the screws all the way down until screws a
the assembly steps a the assembly steps are complete. Position
the entire front assembly on the chassis the entire front asse
and tighten each screw evenly. and tighten ea
TKR1443 TKR1443
TKR5062 TKR5062
Thread Thread
Lock Lock
TKR1344 TKR1344
2, K-3 and K-4 Do not
all the way down until
are complete. Position
embly on the chassis
ch screw evenly.
15