Front End - Tekno RC EB48.3 Building Instructions

Bag H Bag H

Front End

Front End
Step
H-1
Step
H-2
TKR1327
TKR5165
x2
TKR1238
M4x10mm Droop Screw
x2
TKR1327
M3x16mm Flat Head Screw
TKR1333
M3x40mm Flat Head Screw
x2
TKR1522
M3x8mm Cap Head Screw
x2
TKR1529
M3x20mm Cap Head Screw
x6
TKR1601
M3x4mm Set Screw
x2
TKR5049A
Pivot Ball Sway Bar
x2
TKR5079A
Stabilizer Ball
TKR5082 - 2.4mm TKR5082 - 2.4 4 mm
*TKR5080 - 2.2mm *TKR5080 - 2.2 2 mm
*TKR5081 - 2.3mm *TKR5081 - 2.3 3 mm
*TKR5083 - 2.5mm *TKR5083 - 2.5 5 mm
*TKR5084 - 2.6 6 mm *TKR5084 - 2.6mm
*TKR5085 - 2.8 8 mm *TKR5085 - 2.8mm
*TKR5087 - 3.0 0 mm *TKR5087 - 3.0mm
(Option) (Option)
30.2 30.2
TKR5162
TKR5165
TKR1601 TKR1601
TKR5149A
Step
H-3
x2
Use a #19 drill bit or Use a a #19 drill bit or
4mm reamer to ream 4mm reamer to ream
arms until hinge pin arms until hinge pin
falls t t hrough freely. falls through freely.
TKR1601 TKR1601
Note: Do not over-tighten Note: Do not over-tighten
TKR1601 TKR1601
TKR1522 TKR1522
Thread
Lock
TKR5161
TKR5165
TKR5020
TKR1238
TKR1529
TKR5086 TKR5086
Install the sway bar ball onto the Install t the sway bar ball onto the
sway bar wire until the end of sway bar wire until the end of
the wire is flush with the ball as the wi ire is flush with the ball as
Thread
picture above. picture above.
Lock
("B" Block) ("B" Block) ( ( B Block)
St Stock Position tock Position
TKR5086 TKR50 086
TKR1522 TKR1522
TKR1601 TKR1601
L Loosen the M3x4 set screw Loosen the M3x4 set screw
(T (TKR1601) if the anti-roll bar TKR1601) if
does not turn freely. does not turn freely.
TKR1333
("A" Block) ("A" Block)
Stock Position Stock Position
Note: With these stock settings,
Kick Up = 8.5° / Arm Sweep = 0°
For reference, with center dot
inserts in both braces,
Kick Up = 10° / Arm Sweep = 0°
TKR5286
the anti-roll bar
11