Data Commands; Generic Modem Control Commands - Multitech SocketModem MT5600SMI-32 Developer's Manual

Data Commands

The modem will respond to the commands detailed below. Parameters applicable to each command are
listed with the command description.

Generic Modem Control Commands

Command: Z
Description:
Default:
Values:
Result Codes:
Command: +FCLASS
Description:
Default:
Defined Values:
Result Codes:
Report Commands:
Command: +VCID
Description:
Default:
Defined Values:
Report Commands:
Command: +VRID
Description:
Default:
Defined Values:
Report Commands:
Multi-Tech Systems, Inc. SocketModem MT5600SMI Developer's Guide
Chapter 5 – AT Commands, S-Registers, and Result Codes
Soft Reset and Restore Profile
Causes the modem to perform a soft reset and restore (recall) the
configuration profile. If no value is specified, zero is assumed.
None
Number corresponding to the selected profile:
Z0 Soft reset and restore stored profile 0.
Z1 Soft reset and restores stored profile 1.
OK
Otherwise ERROR
Select Active Service Class
Selects the active service class (mode).
0
+FCLASS=0 Select Data Mode (Section 3) (Default).
+FCLASS=1 Select Facsimile Class 1 Mode.
+FCLASS=1.0 Select Facsimile Class 1.0 Mode.
+FCLASS=8 Select Voice Mode.
+FCLASS=10 Reserved.
OK
Otherwise ERROR
+FCLASS? Reports Current or Selected Values
+FCLASS=? Reports Range of Parameters
Caller ID (CID)
Controls the reporting and presentation of data associated with the Caller
ID services in the Incoming Call Line ID (ICLID) data format for the next
call. (U.S. only)
0
+VCID0 Disable Caller ID reporting.
+VCID1 Enables Caller ID with formatted presentation to the DTE. The
modem presents the data items in a <Tag><Value> pair
format. The expected pairs are date, time, name, and caller
code (telephone number).
+VCID2 Enables Caller ID with unformatted presentation to the DTE.
+VCID? Reports the Mode
+VCID=? Reports Range of Parameters
Report Retrieved Caller ID (CID)
Reports the data associated with the Caller ID services in the Incoming
Caller Line (ICLID) data format for the last received call. U.S. only
None
+VRID0 Reports Caller ID with formatted presentation to the DTE. The
modem presents the data items in a <Tag><Value> pair
format. The expected pairs are date, time, name, and caller
code (telephone number).
+VRID1 Reports Caller ID with unformatted presentation to the DTE.
+VRID? Reports the Mode
30