Remote Controls - Elettro CF TIG 118 Instruction Manual

you should briefly press the push-button U as many times as
necessary to display the desired program. P01 will be
displayed the next rime the machine is turned on.
PRESSING THE U PUSH-BUTTON BRIEFLY MAKES A
SELECTION, WHILE HOLDING IT DOWN FOR MORE
THAN 3 SECONDS SAVES THE DATA.
3.6.2. Save from a free program
The operator may edit and save a selected program by
proceeding as follows:
• Press the push-button U briefly and select the desired
program number.
• The symbol of free programs is flashing.
• Press the push buttons C, Z and A4 and select the welding
procedure and mode (paragraph 3.2).
• Turn the knob Q and set the welding current.
• If the TIG procedure has been selected, activate the LED
A5 (post gas) by means of the push-button H, and set the
desired value via the knob Q (paragraph 3.2.)
• If you wish to adjust the "slope" times or other parameters,
after making these adjustments which are necessary in
order to weld, follow the steps described in paragraph 3.2.
• Weld, even briefly, and decide where to save
• To save in the previously selected program, press the
button U for more than 3 seconds, until the number stops
flashing.
• To save in a different program, make your selection by
briefly pressing the push-button U, then hold down the push
button U for more than 3 seconds.
3.6.3. Save from a saved program
Beginning with a previously saved program, the operator may
edit the data in memory to update the program itself, or to
find new parameters to save in another program.
3.6.3.1 Update
• Alter turning on the machine, select the parameters to be
edited and edit them.
• Weld, even briefly.
• Hold down the U button for more than 3 seconds, until the
save is confirmed (program symbol changes from flashing to
steady).
3.6.3.2 Save in a new program
• After turning on the machine, select the parameters to be
edited and edit them.
• Weld, even briefly.
• Briefly press the selector U until the desired program is
displayed.
• Hold down the U button until the save is confirmed
(program symbol changes from flashing to steady).
4.

REMOTE CONTROLS

The following remote controls may be connected to adjust the
welding current for this welding machine:
Item 570008 Foot control (used in TIG welding)
Item 535805 TIG UP/DOWN torch.
Item 535807 TIG UP/DOWN water cooled torch.
Item 530330+ltem 570006 (used in MMA welding)
Item 363307 Connection to simultaneously connect the torch
and the pedal control.
Item 570008 may be used in any TIG welding mode with this
accessory.
Remote controls that include a potentiometer regulate
the welding current from the minimum to the maximum
current set via the knob Q.
Remote controls with UP/DOWN Iogic regulate the
welding current from the minimum to the maximum.
The remote control settings are always active in the PL
program, while they are not active in a saved program.
13