Table of Contents
Advertisement
Infinity iB-16R
Installation
Remove all packing materials from the Infinity iB-16R. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Installing the Lamp
The Showtec Infinity iB-16R uses the Osram Sirius HRI 330W (ordercode 81016) bulb as manufactured by all
popular manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
Always read the safety instructions that are included with the lamp.
Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe off the glass with a clean,lint-free
towel and rubbing alcohol.).
Always read all the safety warnings at the beginning of this manual, before replacing the lamp !!!
Let the lamp cool down for 20 minutes, before replacing the lamp.
Procedure:
01) Loosen the 4 screws (A, B, C, D) on top of the housing.
02) Remove the cover. Make sure you have the right side. Your topside should have the cooling fan.
03) Loosen the 2 screws (E, F) on the back of the housing.
04) Gently remove the small metal housing on the backside.
05) Gently pull the 2 black cables from the lamp.
06) You will now have an unobstructed view of the lamp in its socket.
07) Push the lamp straight downwards with some force (red arrow). The topside of the lamp will now slide
out of its socket. Then gently tilt the lamp and remove the lamp.
08) When installing a new lamp make sure that the lamp is positioned as pictured.
09) Read lamp instructions. Do not touch the lamp bulb glass. (See Figure 3.) Oil on hands shortens the
lamp life. (If you touch the bulb glass, wipe off the glass with a clean, lint-free towel and rubbing
alcohol.).
10) Insert the lamp into lamp socket. You can adjust the distance between the lamp and the lens by
turning the 2 screws (G, H) above or below the lamp.
11) Put the lamp cover back and fasten the screws snugly.
1, 2, 3
Ordercode: 41532
4
5
6
10
7
8
Fig. 03
Advertisement
Table of Contents
