Yamaha WR250F Owner's Service Manual page 145

• Bolt [crankcase cover (left)] "3"
Bolt [crankcase cover
(left)]:
12 Nm (1.2 m•kg, 8.7
ft•lb)
Tighten the bolts in stage, using a
crisscross pattern.
11. Install:
• Washer "1"
• Torque limiter "2"
• Washer "3"
Apply the engine oil to the shaft and
washers.
E
12. Install:
• O-ring
• Cover (idle gear 1) "1"
• Bolt "2"
Bolt:
10 Nm (1.0 m•kg, 7.2
ft•lb)
• Apply the lithium soap base grease
on the O-ring.
• Install the cover (idle gear 1) with its
mark "a" facing upward.
13. Connect:
• AC magneto lead
Refer to "CABLE ROUTING DIA-
GRAM" section in the CHAPTER
2.
AC MAGNETO AND STARTER CLUTCH
14. Install:
• Shift pedal "1"
• Bolt (shift pedal)
Bolt (shift pedal):
12 Nm (1.2 m•kg, 8.7
ft•lb)
When installing the shift pedal onto
the shift shaft, be sure that the center
of the shift pedal is about 1.4 mm
(0.06 in) "a" above the top of the foot-
rest.
5-51