Download  Print this page

Advertisement

i.
Install the brake caliper "8" and
tighten the pad pin "9".
Bolt (brake caliper):
23 Nm (2.3 m•kg, 17
ft•lb)
Pad pin:
18 Nm (1.8 m•kg, 13
ft•lb)
j.
Install the pad pin plug "10".
Pad pin plug:
3 Nm (0.3 m•kg, 2.2
ft•lb)
3. Inspect:
• Brake fluid level
Refer to "CHECKING THE
BRAKE FLUID LEVEL" section.
4. Check:
• Brake lever operation
A softy or spongy feeling
brake system.
Refer to "BLEEDING THE HY-
DRAULIC BRAKE SYSTEM" sec-
tion.
CHECKING AND REPLACING THE
REAR BRAKE PADS
1. Inspect:
• Brake pad thickness "a"
Out of specification
a set.
Brake pad thickness:
6.4 mm (0.25 in)
<Limit>: 1.0 mm (0.04
in)
2. Replace:
• Brake pad
Brake pad replacement steps:
a. Remove the protector "1" and pad
pin plug "2".
b. Loosen the pad pin "3".
c. Remove the rear wheel "4" and
brake caliper "5".
Refer to "FRONT WHEEL AND
REAR WHEEL" section in the
CHAPTER 6.
d. Remove the pad pin "6" and brake
pads "7".
Bleed
e. Connect the transparent hose "8"
to the bleed screw "9" and place
the suitable container under its
end.
Replace as
f. Loosen the bleed screw and push
the brake caliper piston in.
3-19
CHASSIS
Do not reuse the drained brake flu-
id.
g. Tighten the bleed screw.
Bleed screw:
6 Nm (0.6 m•kg, 4.3
ft•lb)
h. Install the brake pad "10" and pad
pin "11".
• Install the brake pads with their pro-
jections "a" into the brake caliper re-
cesses "b".
• Temporarily tighten the pad pin at
this point.
i.
Install the brake caliper "12" and
rear wheel "13".
Refer to "FRONT WHEEL AND
REAR WHEEL" section in the
CHAPTER 6.
j.
Tighten the pad pin "14".
Pad pin:
18 Nm (1.8 m•kg, 13
ft•lb)
k. Install the pad pin plug "15" and
protector "16".
Pad pin plug:
3 Nm (0.3 m•kg, 2.2
ft•lb)
Bolt (protector):
7 Nm (0.7 m•kg, 5.1
ft•lb)

Advertisement

This manual also for:

Wr250fx

Comments to this Manuals

Symbols: 0
Latest comments: