Sony PXW-X400KC Operating Instructions Manual page 18

000 18
1. Overview: Screen Display
Lens Supplied with the PXW-X400KC
The PXW-X400KC is supplied with a lens.
5
4
3
2
1
1.
Iris gain adjustment trimmer (page 39)
2.
Iris push auto switch
When the iris mode switch is in the M (manual)
position, press this switch for instantaneous auto
iris adjustment. The iris is automatically adjusted
while the switch is held down.
3.
Iris mode switch
A (auto): The iris is adjusted automatically.
M (manual): Adjust the iris with the iris ring.
4.
Zoom seesaw switch
This is enabled when the zoom servo/manual
knob is in the SERVO position. Set to the W (wide
angle) position when you want wide-angle, and
set to the T (telephoto) side when you want
telephoto.
Press the switch harder for a faster zoom action, or
softer for slower zoom action.
6
7
8
9
10
11
5.
RET switch
While pressed, the last few seconds recorded
appear on the viewfinder screen (Rec Review)
(page 19).
6.
F.B. lock screw / F.B. adjustment ring
(page 39)
7.
Positioning pin
When attaching the lens, align this pin with the
recess in the top center of lens mount on the
camcorder.
8.
Macro button / macro ring
Press and hold the macro button and turn the
macro ring to adjust the focus (minimum focus
distance: 10 mm).
9.
Iris ring
For manual iris adjustment, set the iris mode
switch to the M (manual) position, then turn this
ring.
[Note]
Always set the iris mode switch to the M (manual) position
first and then adjust the iris.
10.
Zoom lever / zoom ring
For manual zoom adjustment, set the zoom servo/
manual switch to the MANU position, then operate
the lever/ring.
11.
Focus ring
Turn this ring to adjust the focus.
12.
Zoom servo / manual knob
SERVO (servo): Selects power zoom. Operate the
zoom with the zoom seesaw switch.
MANU (manual): Selects manual zoom. Operate
the zoom with the zoom lever/zoom ring.
12
13.
Power/iris control cable
13
Connect to the LENS connector on the camcorder.
14.
VTR switch
14
Use this to start and stop recording. Press once to
15
start recording, then press once more to stop.
15.
Zoom remote control connector
Connect to an optional zoom servo controller to
enable remote control of zooming.