Installing the Spark Plug
Screw the spark plug (3) into the
N
cylinder and fit the boot (2) (press it
down firmly).
BT 360
Engine Running Behavior
If engine running behavior is
unsatisfactory even though the air filter
is clean and the carburetor is properly
adjusted, the cause may be the muffler.
2
Have the muffler checked for
contamination (carbonization) by your
servicing dealer.
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer.
3
Lubricating the Gearbox
Use a mildly alloyed gear oil (see
"Special Accessories") for lubrication of
the gearbox.
Checking Oil Level / Refilling
Check the oil level regularly – once
N
a week in normal operating
conditions.
Remove the auger.
N
2
1
Position the gearbox vertically so
N
that the drilling spindle is horizontal
and the throttle trigger is at the top.
Take out the inspection plug (1).
N
Check the oil level – it must come up
N
to the bottom edge of the hole.
If the oil level does not reach the bottom
edge of the hole, top up with oil.
Take out the filler plug (2).
N
Fill up with oil as far as the bottom
N
edge of the inspection hole.
Refit the inspection and filler plugs
N
with sealing rings and tighten them
down firmly.
English
17