Beta Motorcycles X Trainer 300 2T 2015 Workshop Manual page 73

clutch drum blocking by means of specific tool code
026140010 000.
I
IV
complete clutch and recommended fastening order.
120Nm
A
III
II
10Nm
To unscrew the nut 8 the clutch drum must be
blocked with a relevant tool A (cod. 026140010
000); the clamping torque is set at 120Nm.
Having tightened the nut, bend the two blocking
flaps on the safety plate.
Lubricate the clutch discs with gear oil and pro-
ceed to apply the discs, alternating driving discs
and driven discs.
Notice that the driven discs must be inserted so
that the radius on the teeth faces inwards to-
wards the engine.
Insert the overall thrust bearing 9 (after having
lubricated it with gear oil) in the hole on the
main gearbox shaft and check its free axial slid-
ing.
Close the clutch unit by means of the clutch cap
3, the four springs 13, the fours spring retainers
14 and the four screws 15, to be tightened with
a torque of 10Nm, in a criss-cross pattern.
3
71