Beta Motorcycles X Trainer 300 2T 2015 Workshop Manual page 102

3
Disassembly of central wedges. The extraction of only one
is shown in figure.
4
5
4
Application of reed valve.
100
7
10Nm
6
Remove the two central wedges and remove the
multiflap.
Assemble the multiflap by following the just de-
scribed procedure, in reverse order.
For assembly of the entire intake system, apply
the manifold to the reed valve, followed by the
gasket 4, the spacer 5 and another gasket 4.
Tighten the screws 6 a 10Nm.
Place the two screws 7 in the top holes of the
manifold, without tightening them.