Step 11
Before Lighting
the Fireplace
Step 12
Lighting the
Fireplace
After the
Installation
lighting the fireplace, be sure to do the
following:
Read the
at the beginning of this Installers Guide.
Before lighting the fireplace, double-check the unit
for possible gas leaks.
Before lighting the fireplace, double-check the unit
for possible obstructions that could be blocking the
vent terminations or the front grilles.
Any component that is found to be faulty
replaced with an approved component. Tampering
with the fireplace components is
voids all warranties.
A small amount of air will be in the gas supply lines.
When first lighting the fireplace, it will take a few
minutes for the lines to purge themselves of this air.
Once the purging is complete, the fireplace will light
and will operate normally.
Subsequent lightings of the fireplace will not require this
purging of air from the gas supply lines,
which case the air would have to be purged.
Youve reviewed all safety warnings, youve checked
the fireplace for gas leaks, you know the vent system is
unobstructed, and youve checked for faulty
components. Now youre ready to light the fireplace.
section
and
, in
48