Step 3 Installing The Vent System; Vent System Approvals - Heat-N-Glo SL-950TR Installer's Manual

Step 3
Installing the
Vent System
Vent System
Termination Kits
D-SERIES
DVK-01D
DVK-TVCD
DVK-01TRD
SL D-SERIES
SLK-01D
SLK-TVCD
SLK-01TRD
A. Vent System Approvals
These models have vent starting collars on both the top and
the back of the unit. Depending upon the installation,
decide which ONE set of starting collars will be used to
attached the vent system. The starting collar sealing cap
must remain on the starting collar NOT used.
These models use SL-D-series, direct vent components
when using the vent collars and D-series direct vent
components when using the
The flame and ember appearance may vary based on
the type of fuel burned and the venting configuration used.
Identifying Vent Components
Approved vent system components are labeled for
identification.
instructions are included with each vent termination kit
and should be used in conjunction with this Installers
Guide. Figure 6 shows vent system components and
terminations.
The vent systems installed on this gas fireplace may
include one, two, or three 90° elbow assemblies. The
relationships of vertical rise to horizontal run in vent
configurations using 90° elbows
adhered to. The rise to run relationships are shown in the
venting drawings and tables on the next several pages.
Two 45° elbows may be used in place of one
90° elbow. You
and rise-to-run ratios in the vent system
when using 45° elbows.
Vent System Components
vent collars.
. Detailed installation
always maintain the
strictly
10